Yealink SIP-T21 Bedienungsanleitung PDF herunterladen (Seite 115)

Advanced Phone Features

105

involved.

The multicast paging key LED illuminates solid green.

The following figure shows a multicast RTP session on the phone:

2. Press the Hold soft key to place the current multicast RTP session on hold.

3. Press the Cancel soft key to cancel the multicast RTP session.

Note

You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from

the pre-configured multicast address(es) without involving SIP signaling. You can

specify up to 10 multicast addresses that the phone listens to on the network.

How the phone handles incoming multicast paging calls depends on Paging Barge and

Paging Priority Active parameters configured via web user interface.

Paging Barge

Paging barge parameter defines the priority of the voice call in progress. If the priority

of an incoming multicast paging call is lower than that of the active call, it will be

ignored automatically. If Disabled is selected from the pull-down list of Paging Barge,

the voice call in progress takes precedence over all incoming multicast paging calls.

Valid values in the Paging Barge field:

 1 to 10: Define the priority of an active call, 1 with the highest priority, 10 with the

lowest.

 Disabled: The voice call in progress shall take precedence over all incoming

paging calls.

Paging Priority Active

Paging priority active parameter decides how the phone handles the incoming

multicast paging calls when there is already a multicast paging call on the phone. If

enabled, the phone will ignore incoming multicast paging calls with lower priorities,

otherwise, the phone will answer incoming multicast paging calls automatically and

place the previous multicast paging call on hold. If disabled, the phone will

automatically ignore all incoming multicast paging calls.

Multicast RTP is one way only from sender to the multicast address(es) (receiver). For

outgoing RTP multicasts, all other existing calls on the phone will be placed on hold.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 141 142

Keine Kommentare

Yealink SIP-T21 Bedienungsanleitung Seite 115